Application of lifting lighting floodlight

Time：2021-03-17 View：

Application
Floodlights are directed from a specific point to each
It is best to use it to simulate bulbs and candles by irradiating objects evenly in all directions.
Main Scope of Application: billboards, highways, railway tunnels, bridges and culverts, squares, buildings, etc.
omni: floodlight is a kind of "point light source" that can irradiate evenly in all directions. Its irradiation range can be adjusted arbitrarily, which can produce projection shadows on objects. Floodlight is the most widely used light source in the effect diagram. "standard floodlight" is used to illuminate the whole scene without any specific range. Multiple floodlights can be used to coordinate in the scene to produce better results. It should be noted that floodlights cannot be built too much, otherwise the effect diagram will appear plain and dull. Therefore, we should pay more attention to the influence of lighting parameters and layout on the light sense of the whole rendering scene in the ordinary rendering production, accumulate more experience and master the matching skills of lighting.

LED
LED floodlight is a kind of point light source that can irradiate evenly in all directions. Its illumination range can be adjusted arbitrarily, which is shown as a regular octahedral diagram in the scene. Floodlight is the most widely used light source in rendering production. Standard floodlight is used to illuminate the whole scene. Multiple floodlights can be applied in the scene to produce better results. Floodlight is the most widely used light source in the effect diagram. Multiple floodlights can be used to coordinate in the scene to produce better results. It irradiates objects evenly from a specific point to all directions.

 

Features
Floodlight irradiates objects evenly from a specific point to all directions.

 

Installation
Materials needed: led guardrail light clip, transformer with waterproof function, Branch Controller, steps are as follows:
1. Install the guardrail and punch holes on the wall. The spacing is generally within 3cm according to the actual requirements;
2. Take anti-static measures, for example, the Workbench should be grounded, workers should wear corresponding anti-static clothing, anti-static measures, because the quality of LED floodlights of different grades is different, and the anti-static ability is different;
3. Pay attention to the tightness of the installation, the tightness is not good, and the diameter affects the service life of the LED floodlight;
4. The wiring of LED floodlight should not exceed 25cm. Those with high transformer power can be lengthened accordingly, otherwise the brightness will be affected.

 

Attention
1. Try to use the serial LED form, because the voltage difference of LED floodlights is special. The peak current of ordinary LED is maintained at 80 mA, and the backward voltage is around 6V. When LED is applied, pay attention to the peak voltage and current when designing the circuit under this limit.
2. Use voltage below 25W when welding, electric soldering iron temperature is controlled below 300 degrees Celsius and exposed SMD LED under high temperature state, do not squeeze its epoxy resin part, or wipe with sharp hard objects, because LED lamp is very fragile and easily damaged, the welding time is 3 seconds.
LED floodlights are widely used, so the installation skills and precautions are very important. LED is a new light source. Under the correct installation mode, it can ensure the stable and long-term normal operation of LED floodlights.